Forum Navigation
Please Login to create posts and topics.
Post History: TomVanAllen
2 years ago
Who else makes 3/4 ounce wads in 12 gauge…. Besides Claybuster?In: Stack height issue with 3/4ounce 12 gauge loads
2 years ago
In a recent podcast with Tom Gresham, Joel Hodgdon left the window wide open to bringing back the Gr …In: Stack height issue with 3/4ounce 12 gauge loads
2 years ago
I bought a used Spolar Gold this morning.
the Dillon SL900 did great with 1 ounce and a …In: Stack height issue with 3/4ounce 12 gauge loads
2 years ago
Having switched over to the metallic green Remington STS hulls just last night, there was some trial …In: Stack height issue with 3/4ounce 12 gauge loads
2 years ago
That digital display reads 1.399”.
If I was really smart / on the ball, when I had my 9 …In: Stack height issue with 3/4ounce 12 gauge loads
2 years ago
The final height for the shot dispenser / shot drop tube was this:In: Stack height issue with 3/4ounce 12 gauge loads
2 years ago
It’s been a few weeks, I figured better get back in here to post what I think my solution is/was.
…In: Stack height issue with 3/4ounce 12 gauge loads
2 years ago
One last thing, I have plenty of the gold colored Remington Nitro 27 once fired hulls around. I tr …In: Stack height issue with 3/4ounce 12 gauge loads
2 years ago
You’ll see that the (yellow zinc coated?) adjuster bolt is almost flush with the body collar. You c …In: Stack height issue with 3/4ounce 12 gauge loads
2 years ago
As far as the shot dispenser height goes to drop a 3/4 ounce load with these Clay Buster 0175-12 wad …In: Stack height issue with 3/4ounce 12 gauge loads
2 years ago
This is what the two shot bars look like…
The original 12 gauge shot bar that is good for an ounc …In: Stack height issue with 3/4ounce 12 gauge loads
2 years ago
With that much drag on the shot bar, it was kept from going its full stroke.
So I went …In: Stack height issue with 3/4ounce 12 gauge loads
2 years ago
The “gate” was scraping so much across the white rubber “snubber” that it was leaving a white powder …In: Stack height issue with 3/4ounce 12 gauge loads
2 years ago
Thank you for all the replies The Human Manual.
I finally figured it out.
Since the …In: Stack height issue with 3/4ounce 12 gauge loads
2 years ago
Yep! Tried that already.
It is almost like the shot drop tube is too long. And then t …In: Stack height issue with 3/4ounce 12 gauge loads
2 years ago
The thought had crossed my mind to switch to a bulkier powder with the hopes of that raising the he …In: Stack height issue with 3/4ounce 12 gauge loads
2 years ago
The “before pic” with the Dillon SL900 and the same WT12 wad;
In: Stack height issue with 3/4ounce 12 gauge loads
2 years ago