300 BO and Trim Die
Quote from Reloader on December 24, 2014, 5:43 amI purchased the 300 Blackout trim die and the 1500 trim motor. I also have the special head that holds the trim die. When I trim the brass I get a ball of string brass that does not change no matter fast or how slow I lower the handle to engage the die and trim head. Can anyone offer suggestions? Is this normal or do I have something wrong? TIA
I purchased the 300 Blackout trim die and the 1500 trim motor. I also have the special head that holds the trim die. When I trim the brass I get a ball of string brass that does not change no matter fast or how slow I lower the handle to engage the die and trim head. Can anyone offer suggestions? Is this normal or do I have something wrong? TIA
Quote from Reloader on December 25, 2014, 2:56 pmI figured out I was trying to run the machine to slow. When I went a little faster the cutter head trimmed like a champ.
I figured out I was trying to run the machine to slow. When I went a little faster the cutter head trimmed like a champ.
Quote from Reloader on May 1, 2015, 12:39 pmWhat we use is a 1 1/2 inch vac hose cut to 10 inches into a 2" hose going to a big shop vac. We do get bird nesting but not as bad. This is running over 4,000 cases a day.
What we use is a 1 1/2 inch vac hose cut to 10 inches into a 2" hose going to a big shop vac. We do get bird nesting but not as bad. This is running over 4,000 cases a day.