300AAC case feed
Quote from Reloader on January 29, 2020, 1:36 amwhich specific parts are needed to outfit the casefeeder to feed 300AAC case mouth up instead of mostly case mouth down?
which specific parts are needed to outfit the casefeeder to feed 300AAC case mouth up instead of mostly case mouth down?
Quote from Reloader on January 29, 2020, 2:58 pmI use a large pistol plate with two spacer washers under the clutch assembly. I had to get longer screws for the assembly but its worked for me for years.
The other conversion parts needed for the 650 are:
shell plate: #3
locator buttons : #3
funnel: AK
stn. 1 locator: #3
case feed adapt: blue
arm bushing: green
bod bushing: smallJJ
I use a large pistol plate with two spacer washers under the clutch assembly. I had to get longer screws for the assembly but its worked for me for years.
The other conversion parts needed for the 650 are:
shell plate: #3
locator buttons : #3
funnel: AK
stn. 1 locator: #3
case feed adapt: blue
arm bushing: green
bod bushing: small
JJ
Quote from Reloader on April 2, 2020, 11:17 pmI stay with the small rifle plate. If you use a flat blade screwdriver, you can move the metal piece @ the opening (area where the cases fall) approx 3/4 inch...closing off the opening. Mine fall base down every time.....works great.
I stay with the small rifle plate. If you use a flat blade screwdriver, you can move the metal piece @ the opening (area where the cases fall) approx 3/4 inch...closing off the opening. Mine fall base down every time.....works great.