375 Ruger, 28 Nosler, 6.5 creedmoor

#1 · April 20, 2018, 4:11 am

I’ve got an xl650 with auto case feeder and the required parts and conversion kits to load for 9mm, 40 s&w, and 223.

I’d like to set up to load for my 28 Nosler, 375 ruger, and 6.5creedmoor. What parts do i need to accomplish this, excluding dies?

Thank you.

Casey

#2 · April 20, 2018, 2:27 pm

We have conversion kits for 6.5 Creedmoor ( #62245) and 28 Nosler ( #62298). We haven't worked one up for 375 Ruger, but can probably do so.
For 28 Nosler you will need the Belted Magnum Powder System (#97126) and a toolhead (#13863) if you wish to leave your dies preset. The 650 Quick Change (#22059) will suffice for 6.5 Creedmoor.

#3 · April 20, 2018, 3:33 pm

Thank you for such a quick response.

That is way fewer parts than I was expecting. Can you give me a caliber specific run-down? I am sure I at least need a new shell plate for the auto case feeder, unless I can't auto-feed the 28.

Large rifle case feeder for the 6.5?

I'm trying to avoid buying a ton of extra parts that I end up not needing.

I would like to set up each caliber on a dedicated toolhead.

Thanks again

#4 · April 23, 2018, 5:28 pm

6.5 Creedmoor uses:
6.5 shellplate
6.5 Grendel powder funnel
#1 station One Locator
3-#1 brass locator pins
Orange modified case feed adapter (22-250, 7.62 x 39)
Large case feed body bushing
white rifle case feed arm bushing
large rifle casefeed plate

28 Nosler uses:
Magnum Case Feed Assembly, #11069 ( includes arm bushing and body bushing )
B shellplate
3-#4 brass locator pins
7mm Short Magnum powder funnel
Black magnum rifle case feed adapter
Magnum rifle casefeed plate

#5 · April 27, 2018, 1:29 pm

Thank you so much for your help, I appreciate it.