.45 ACP die bent pin

#1 · September 13, 2016, 7:46 pm

I have a Dillion .45 ACP die and the little decapping pin that fits inside the screw on to the main shaft is bent. Where I can I get a replacement? I can't find them on the site.

#2 · September 14, 2016, 4:50 pm

A spare depriming pin is packed in the die box.
We sell pistol depriming pins in ten-packs. #21528 $5.75
All Dillon handgun dies use the same size depriming pin, with the exception of 357 SIG. 357 SIG uses a smaller diameter pin, as some brands of brass have flash holes smaller than standard dimensions.

#3 · September 15, 2016, 5:35 pm

Do you have the part number for the 357 SIG decapping pins? I am using a set of 40 dies for resizing and ran into the tiny speer and r-p flash holes. i wouldnt mind ordering a few extra for the 40 dies i have.

#4 · September 16, 2016, 2:27 pm

The part number is 19965, $1.35 each

#5 · December 5, 2016, 7:54 pm

Can the little threaded collet that holds the decapping pin be ordered? I have one that split like it was a two piece pressed together part at one time. I have been swapping that out between dies and would like to order a couple if I can.

Thanks.

#6 · December 6, 2016, 4:45 pm

Please send us an email with your name and address, we'll mail a couple to you.