9mm not ejecting
Quote from Reloader on February 4, 2013, 10:28 pmThis is my first conversion from the factory 45ACP. I got the 9mm conversion kit and a 650 quick change kit and 9mm dies. All goes well until I get to the "Eject" station and the rounds (50-50 chance) hang on the ejector wire causing the machine to jam. I installed the ejector wire from my spare parts kit and the same thing happens. Any tips?
This is my first conversion from the factory 45ACP. I got the 9mm conversion kit and a 650 quick change kit and 9mm dies. All goes well until I get to the "Eject" station and the rounds (50-50 chance) hang on the ejector wire causing the machine to jam. I installed the ejector wire from my spare parts kit and the same thing happens. Any tips?
Quote from Reloader on February 5, 2013, 4:46 pmBe sure the ejector wire is wrapped around the head of the shellplate bolt, and not underneath it. Push down on the edge of the shellplate at station 4. If it feels springy, then the shellplate bolt needs to be tighter.
Be sure the ejector wire is wrapped around the head of the shellplate bolt, and not underneath it. Push down on the edge of the shellplate at station 4. If it feels springy, then the shellplate bolt needs to be tighter.
Quote from Reloader on March 24, 2013, 6:34 pmmake sure the end of the wire in seated in that little hole that no one tells you about.....as well as the wire not being under the bolt. The manual doesn't mention either one..........
make sure the end of the wire in seated in that little hole that no one tells you about.....as well as the wire not being under the bolt. The manual doesn't mention either one..........