9mm seating stem

#1 · November 22, 2014, 6:43 am

Just wanted to say thanks to Dillon customer service. Seems my 9mm seating stem was bad from the factory. The SWC side was ok, but what was supposed to be the RN side was completely flat, did not have the RN profile machined in. Since it was labeled "9/38", I had just assumed it was for 38 wad cutters. Anyway, the tech rep (don't remember his name) said he would send out a replacement, which I just got. Thanks.

Just so he doesn't think I was making it up, here is a photo:

#2 · November 24, 2014, 2:29 pm

That is the 38 Spl wadcutter seat stem. Our apologies for the error.