Brass moving back when depriming.

#1 · April 15, 2018, 6:42 pm

Hi...

When I put a clean piece of brass in the first stage to deprime, the brass moves back out and hits the die when going up.I have to use my finger to push the brass in the shell plate. Then it will go up to deprime. It doesn't happen all the time, but way more after installing my replacement handle a few weeks ago. Let me know if there is anything I can fix on my side.

Thanks

#2 · April 15, 2018, 10:42 pm

I also wanted to add. The shell plate was replaced in 5-7-14 aprox: 17k rnds since then.

#3 · April 16, 2018, 9:42 pm

Cancel...The press wasn't level, of course it was leaning more toward the handle.