Case feeder binding
Quote from Mginkel on April 15, 2024, 5:38 amHello, I just purchased and 750 with case feeder . I am trying set up for 9mm . I have the small pistol feeder wheel installed but after feedin 5-10 cases it jams . It appear the cases get wedged between the wheel and side of bowl. I have tried to tighten the wheel which helped a bit , but jams still occur frequently . Any help is appreciated
Hello, I just purchased and 750 with case feeder . I am trying set up for 9mm . I have the small pistol feeder wheel installed but after feedin 5-10 cases it jams . It appear the cases get wedged between the wheel and side of bowl. I have tried to tighten the wheel which helped a bit , but jams still occur frequently . Any help is appreciated
Quote from The Human Manual on April 15, 2024, 3:37 pmYou probably need to adjust the blue block bolted inside the bowl. Raise the leading edge, and lower the trailing edge.
You probably need to adjust the blue block bolted inside the bowl. Raise the leading edge, and lower the trailing edge.
Quote from Mginkel on April 15, 2024, 3:57 pmNot exactly sure what you mean ? There wheel attaches via a key lock , so I don’t see anything to adjust under the gear plate . Do mean the two Allan screws on the outside of the gear plate ( those that are visible when I look into bowl ) ?
Not exactly sure what you mean ? There wheel attaches via a key lock , so I don’t see anything to adjust under the gear plate . Do mean the two Allan screws on the outside of the gear plate ( those that are visible when I look into bowl ) ?
Quote from The Human Manual on April 15, 2024, 4:28 pmTHis blue block is bolted to the inside wall of the bowl. On the outside you can see the two bolt heads.
THis blue block is bolted to the inside wall of the bowl. On the outside you can see the two bolt heads.