Case feeder misaligned?
Quote from Reloader on September 2, 2018, 4:23 amI need your help guys, recently I bought an RL 1050 from a friend, he does not gave me the case feeder so I tried to install the case feeder from my XL650, as I undestand that the casefeeders can be interchangeable between the 650 and 1050/Super 1050 since the plastic bowl is molded to fit over both the square and round posts.
But for some reason after mounted it on RL1050 Squared post It is not aligned with the case feeder tube, is slightly turned to the left.
Here a link to a picture I took:
http://i40.photobucket.com/albums/e207/aasp76/case%20feeder%20misaligned_zpsypsrki7i.jpeg
Any idea ?
I need your help guys, recently I bought an RL 1050 from a friend, he does not gave me the case feeder so I tried to install the case feeder from my XL650, as I undestand that the casefeeders can be interchangeable between the 650 and 1050/Super 1050 since the plastic bowl is molded to fit over both the square and round posts.
But for some reason after mounted it on RL1050 Squared post It is not aligned with the case feeder tube, is slightly turned to the left.
Here a link to a picture I took:
http://i40.photobucket.com/albums/e207/aasp76/case%20feeder%20misaligned_zpsypsrki7i.jpeg
Any idea ?
Quote from Reloader on September 6, 2018, 3:00 amI have a new Super 1050 I got earlier this year and have noticed the same issue. The case feed system is not in line. Seems like the case feeder is turned a few degrees toward the front, but its rigid mounted to the tube and frame. I'd post a picture but this platform does not seem to allow that.
I have a new Super 1050 I got earlier this year and have noticed the same issue. The case feed system is not in line. Seems like the case feeder is turned a few degrees toward the front, but its rigid mounted to the tube and frame. I'd post a picture but this platform does not seem to allow that.
Quote from Reloader on September 6, 2018, 11:04 amDillon,
I cut and pasted the picture and I see it. I don't have a solution to asandoval's issue, but did verify that both the 650 and 1050 bowl's have the same part #.
Dillon,
I cut and pasted the picture and I see it. I don't have a solution to asandoval's issue, but did verify that both the 650 and 1050 bowl's have the same part #.
Quote from Reloader on September 21, 2018, 5:06 pmThere are two sets of holes in the 1050 frame, with new casefeeders you'll need to use the rear holes. With older casefeeders you might need to use the front holes.
There are two sets of holes in the 1050 frame, with new casefeeders you'll need to use the rear holes. With older casefeeders you might need to use the front holes.