Case feeder problem
Quote from Reloader on April 20, 2020, 3:43 pmHi,
My case feeder stops from time to time, and I can get it turning again if I help it along a bit. Sometimes just a little bit, but sometimes I have to turn the plate about 90 degrees.
I have tried cleaning it up, and adjusting the clutch, but it keeps stopping anyway. It also doesn't matter if I have 50 or 250 casings in it.
Today I noticed that the clutch parts were a little bit warm after a particulary difficult session.Is the motor dying on me?
PS. It has always been weak, and I have never been able to fill it with more than about 250 9 mm casings.
Regards
/Toby
Hi,
My case feeder stops from time to time, and I can get it turning again if I help it along a bit. Sometimes just a little bit, but sometimes I have to turn the plate about 90 degrees.
I have tried cleaning it up, and adjusting the clutch, but it keeps stopping anyway. It also doesn't matter if I have 50 or 250 casings in it.
Today I noticed that the clutch parts were a little bit warm after a particulary difficult session.
Is the motor dying on me?
PS. It has always been weak, and I have never been able to fill it with more than about 250 9 mm casings.
Regards
/Toby
Quote from Reloader on April 20, 2020, 5:41 pmIt sounds like the motor is dying. https://www.dillonprecision.com/casefeeder-assembly-parts_8_45_25391.html
It sounds like the motor is dying. https://www.dillonprecision.com/casefeeder-assembly-parts_8_45_25391.html