Case feeder Problem???
Quote from Reloader on March 15, 2009, 12:10 amJust received a BRAN NEW XL650 to replace my old 650. But, my case feeder will not fit on the new 650..The case feeder can not go down far enough to sit right on the pole, also, the case feed screw to tighten to the pole came out???
My case feeder is over 10-12 Y/o???? Could this be the problem with the slight changes on the newer 650???
Just received a BRAN NEW XL650 to replace my old 650. But, my case feeder will not fit on the new 650..The case feeder can not go down far enough to sit right on the pole, also, the case feed screw to tighten to the pole came out???
My case feeder is over 10-12 Y/o???? Could this be the problem with the slight changes on the newer 650???
Quote from Reloader on March 19, 2009, 10:29 pmThere should not be any issues preventing use of your older case feeder on the new 650. Look for casting flash up in the hole that might prevent it from going down far enough. overtightening the screw will casue the helicoil to pull out. No big problem, use a self-tapping sheet metal screw instead. All this screw does is prevent the case feed bowl from rotating.
There should not be any issues preventing use of your older case feeder on the new 650. Look for casting flash up in the hole that might prevent it from going down far enough. overtightening the screw will casue the helicoil to pull out. No big problem, use a self-tapping sheet metal screw instead. All this screw does is prevent the case feed bowl from rotating.