Case Insertion
Quote from Reloader on April 27, 2013, 6:46 pmHello excuse my ignorance with nomencalature i am new to this press . The issue I am having is when the case is being pushed into the rotating plate it does not seem to get pushed all the way in so when it goes up into the decapping die it either jams and needs a jiggle to line up . am I messing something I see no adjustment for this? I am loading 9MM luger
Hello excuse my ignorance with nomencalature i am new to this press . The issue I am having is when the case is being pushed into the rotating plate it does not seem to get pushed all the way in so when it goes up into the decapping die it either jams and needs a jiggle to line up . am I messing something I see no adjustment for this? I am loading 9MM luger
Quote from Reloader on April 28, 2013, 4:50 amAlso check the shellplate groves where the case slide in. I had a similar issue. I found that a little powder and debri can makes its way into the grooves where the case sits and prevents the case from seating all the way in.
A little paperclip works great to wipe the groove clean.
Also check the shellplate groves where the case slide in. I had a similar issue. I found that a little powder and debri can makes its way into the grooves where the case sits and prevents the case from seating all the way in.
A little paperclip works great to wipe the groove clean.
Quote from Reloader on May 3, 2013, 1:11 amI had the same problem. As mentioned, push the handle forward and also, make sure there is nothing keeping the handle from going all the way down. Mine was hitting a mounting bolt just barely but it wreaked havoc on the case feeding. I cut the bolt off and it works great now.
I had the same problem. As mentioned, push the handle forward and also, make sure there is nothing keeping the handle from going all the way down. Mine was hitting a mounting bolt just barely but it wreaked havoc on the case feeding. I cut the bolt off and it works great now.