Cases misaligned in stations 1 and 2

#1 · May 27, 2020, 1:46 pm

Hello,
The 9mm brass in station 1 of my 550c keeps hitting the bottom of the die when I press/raise. It leans out/away from the shell plate causes the misalignment. The spring is just contacting the bottom of the brass and I’ve pressed about 4K rounds through it already with no issues. The same issue tends to happen in station 2. Any suggestions?

Thanks
Jeff

#2 · May 27, 2020, 1:51 pm

Nevermind, it was the shellplate that needed tightening.