Dillon Roller Handle Install Question
Quote from Reloader on March 18, 2013, 12:45 amI recently acquired an aluminum roller handle for my xl650. I noticed that it had two washers supplied with it and the threads were shorter in overall length than the stock ball handle threads. My question is where do the two washers go? Does one go on top (where the shaft enters) and the other on the bottom (where it exits) and then the nut? Or do both washers go on top? Or do you only need one washer? If anyone can help me out I'd appreciate it. Thanks in advance!
I recently acquired an aluminum roller handle for my xl650. I noticed that it had two washers supplied with it and the threads were shorter in overall length than the stock ball handle threads. My question is where do the two washers go? Does one go on top (where the shaft enters) and the other on the bottom (where it exits) and then the nut? Or do both washers go on top? Or do you only need one washer? If anyone can help me out I'd appreciate it. Thanks in advance!
Quote from Reloader on March 18, 2013, 2:14 amIf ya look at the video it show both washers used one on top other on the bottom b4 the nut
If ya look at the video it show both washers used one on top other on the bottom b4 the nut
Quote from Reloader on June 19, 2013, 9:35 amJust goes to show you I looked at my washer setup and had it wrong. (bloody males we never look at instructions)
Just goes to show you I looked at my washer setup and had it wrong. (bloody males we never look at instructions)