emptying the powder resevoir
Quote from Reloader on December 8, 2013, 7:10 pmWas wondering if there is another way other than removing the toolhead and pouring it out.
Was wondering if there is another way other than removing the toolhead and pouring it out.
Quote from Reloader on December 14, 2013, 4:03 pmJust like you would change the charge bar. Remove the powder resevoir itself and empty.
Just like you would change the charge bar. Remove the powder resevoir itself and empty.
Quote from Reloader on December 23, 2013, 3:34 amI use the Drain N Change tool by Uniquetek. It takes some practice to use properly, but once you understand the procedure, it works really well. All you have to do is loosen the bellcrank bolt, disengage the bellcrank cube, & slide the powder bar out while slipping in the drain tool bar in its place. The drain tool has a slanted hole in it which drains the powder. A powder funnel makes the process easier, as well. This tool also allows you to change powder bars without draining the powder, as well.
I use the Drain N Change tool by Uniquetek. It takes some practice to use properly, but once you understand the procedure, it works really well. All you have to do is loosen the bellcrank bolt, disengage the bellcrank cube, & slide the powder bar out while slipping in the drain tool bar in its place. The drain tool has a slanted hole in it which drains the powder. A powder funnel makes the process easier, as well. This tool also allows you to change powder bars without draining the powder, as well.