fail safe rod

#1 · November 30, 2010, 12:59 pm

i think it's a fail safe rod but i'am not sure, but it's the rod that comes off the powder measurer. i just bought the press and the rod is bent just wondering what i need to do to get a replacement

#2 · November 30, 2010, 4:01 pm

Phone or e-mail us with your address and machne model, and we'll mail a replacement.

#3 · November 30, 2010, 8:27 pm

thanks for the quick responce i have been a dillon owner for just a few days and already i'm inpressed with your exceptional customer service.

#4 · November 30, 2010, 8:38 pm

thanks for the quick responce i have been a dillon owner for just a few days and already i'm inpressed with your exceptional customer service.

#5 · November 30, 2010, 11:55 pm

some.. great guys at dillon are exceptional

#6 · September 21, 2011, 8:22 am

I have a problem with the primer plastic follower but not the powder measure, it is kinked and does not follow all the way down.

#7 · December 21, 2011, 4:56 pm

primer follower is part number 13707

#8 · October 11, 2012, 6:25 am

Sorry to take so long but it is a 13629 but I have reformed it to the correct angles an all is fine but would like you to replace the primer follower rod as it has become distorted and does not indicate the primers have emptied and does not follow them down (1/3 up it stays stuck) I can push it down but forget and then have problems.
Will email my details, thank you. Bob