Quote from
Reloader on January 11, 2010, 7:56 pm
I have a SDB and would not trade it for the world. Very consistant. I recently purchased a new barrel from storm lake for a g34. In the past my 9mm loads worked perfect in the factory barrel. Rounds were jamming in the Storm lake barrel. I measured the diameter of the case mouth with the seated bullet and found it to be .382. Winchester rounds were .375. I went back and attempted to recrimp a few rounds, but cannot get the slight bell out of the finished round( .382). The crimping die has had about 2k rounds through it. Any ideas?
I have a SDB and would not trade it for the world. Very consistant. I recently purchased a new barrel from storm lake for a g34. In the past my 9mm loads worked perfect in the factory barrel. Rounds were jamming in the Storm lake barrel. I measured the diameter of the case mouth with the seated bullet and found it to be .382. Winchester rounds were .375. I went back and attempted to recrimp a few rounds, but cannot get the slight bell out of the finished round( .382). The crimping die has had about 2k rounds through it. Any ideas?
