index pawl
Quote from Reloader on November 28, 2014, 11:09 pmI have a super 1050 and my index pawl broke. I have tried to get the pin out but cannot seem to have any luck doing it. How am i supposed to take this thing out to replace the index pawl?
I have a super 1050 and my index pawl broke. I have tried to get the pin out but cannot seem to have any luck doing it. How am i supposed to take this thing out to replace the index pawl?
Quote from Reloader on November 26, 2014, 3:58 pmThe pin will tap out using a proper diameter punch and a hammer. There might be a tiny burr where the pawl rotates on the pin, so hit it harder as necessary
The pin will tap out using a proper diameter punch and a hammer. There might be a tiny burr where the pawl rotates on the pin, so hit it harder as necessary
Quote from Reloader on November 28, 2014, 11:13 pmWe have tried that using the correct punch. It will not budge one bit. Alls that did was bust the pin. Any other suggestions??
We have tried that using the correct punch. It will not budge one bit. Alls that did was bust the pin. Any other suggestions??
Quote from Reloader on December 1, 2014, 7:19 pmWe have tried that using the correct punch. It will not budge one bit. Alls that did was bust the pin. Any other suggestions??
We have tried that using the correct punch. It will not budge one bit. Alls that did was bust the pin. Any other suggestions??
Quote from Reloader on December 2, 2014, 7:50 pmwe use a shorter punch, about 1 1/2" long, to start removing the pin. Then use a standard punch to finish removal. You are welcome to send the index lever to us for removal of the pin, so you don't destroy the part.
we use a shorter punch, about 1 1/2" long, to start removing the pin. Then use a standard punch to finish removal. You are welcome to send the index lever to us for removal of the pin, so you don't destroy the part.