Indexing problem
Quote from Reloader on July 8, 2013, 5:02 pmPulled the shell plate to blow excess powder from under the shell case holder and know won't index properly. Just got done running 500 40 S &W though it. Any suggestions? Won't index forward but did index in reverse.
Pulled the shell plate to blow excess powder from under the shell case holder and know won't index properly. Just got done running 500 40 S &W though it. Any suggestions? Won't index forward but did index in reverse.
Quote from Reloader on July 22, 2013, 2:08 amI would be willing to bet that you have the shell plate bolt too tight. Loosen the set screw, back the shell plate bolt a bit until you can index it by hand. Tighten the set screw, and you should bet set.
I would be willing to bet that you have the shell plate bolt too tight. Loosen the set screw, back the shell plate bolt a bit until you can index it by hand. Tighten the set screw, and you should bet set.
Quote from Reloader on July 22, 2013, 3:56 pmBe sure the tomahawk-shaped index pawl is installed correctly (broad edge facing left) and that the detent ball is in place under the shellplate.
Be sure the tomahawk-shaped index pawl is installed correctly (broad edge facing left) and that the detent ball is in place under the shellplate.