infeed problem

#1 · April 26, 2008, 2:20 pm

I have been sizing .233 brass on my 650 using Dillon case lube. The problem I have been having is that the infeed block keeps tipping my brass over and causes misfeeding. Is the case lube just too sticky on the head of the case to use in the 650? I polished the infeed slide thing( I don't know the proper terminology, but I can look it up if you feel the need to bust my b*lls) but I wonder if this being smoother will increase the surface tension of the lube and the sliding pieces and compound my problem? Would I be better off using Hornady's One Shot?

#2 · April 28, 2008, 11:00 pm

What caliber, if any, were you loading on the 650 prior to converting to 223?

#3 · May 3, 2008, 6:43 am

nothing, it came from the facory with the .223 conversion installed

#4 · May 3, 2008, 3:37 pm

Push down on the edge of the shellplate at station 4. If it feels springy, then tighten the shellplate bolt down a bit more.