loading small primer .45
Quote from Reloader on May 10, 2013, 2:44 amI have a Dillon xl 650 setup for 9mm. I would like to load some .45acp small primer brass. My question is, do I need to make any adjustments to the primer seating for .45 or will it center with my 9mm setup? Thanks
Quote
MultiQuote
I have a Dillon xl 650 setup for 9mm. I would like to load some .45acp small primer brass. My question is, do I need to make any adjustments to the primer seating for .45 or will it center with my 9mm setup? Thanks
Quote
MultiQuote
Quote from Reloader on September 6, 2013, 3:33 pmAssuming you will have the correct shellplate installed you will have to adjust the Station 2 locator tab. If it is set for 45 auto cases there will be too much space between it and the 9mm cases without adjusting. The instructions to adjust the Locator tab are in the XL-650 manual on page 39, step 17. If you don't make that adjustment the space between the 9mm cases and the tab will allow for some case travel and that can allow case alignment to get off. That really should be all you have to do as far as the primer system is concerned.
Assuming you will have the correct shellplate installed you will have to adjust the Station 2 locator tab. If it is set for 45 auto cases there will be too much space between it and the 9mm cases without adjusting. The instructions to adjust the Locator tab are in the XL-650 manual on page 39, step 17. If you don't make that adjustment the space between the 9mm cases and the tab will allow for some case travel and that can allow case alignment to get off. That really should be all you have to do as far as the primer system is concerned.