Metal on Metal grinding
Quote from Reloader on May 15, 2015, 9:42 pmRecently I have experienced a lot of restriction and a feel of metal grinding in the uplift position.
This is 45acp reloading, im thinking there's too much bell coming out of the powder fill position.
This will be checked today, just wanted to see if that's a good prediction.
Recently I have experienced a lot of restriction and a feel of metal grinding in the uplift position.
This is 45acp reloading, im thinking there's too much bell coming out of the powder fill position.
This will be checked today, just wanted to see if that's a good prediction.
Quote from Reloader on May 15, 2015, 10:47 pmCheck for dirty/dry pivot arm pins. Page 3 part 13700 in the users manual. Remove Link Arms, clean and grease. If the pivot arms pins are dry/dirty, then the The Main Shaft Pivot Pin will need cleaning/grease, too.
Check for dirty/dry pivot arm pins. Page 3 part 13700 in the users manual. Remove Link Arms, clean and grease. If the pivot arms pins are dry/dirty, then the The Main Shaft Pivot Pin will need cleaning/grease, too.
Quote from Reloader on May 16, 2015, 2:33 pmI only feel this restriction when I have a case in the plate. When I pull back on the handle that's when I feel that metal on metal grind, like its in the die when in contact with the brass.
I only feel this restriction when I have a case in the plate. When I pull back on the handle that's when I feel that metal on metal grind, like its in the die when in contact with the brass.