need help w/1050
Quote from Reloader on August 4, 2010, 6:54 pmI have had great service from my 1050 however it has gone out of alignment and I can seem to get it right. If anyone lives in the Long Island NY area HELP ME PLEASE. I have been unable to load anything for months.
I have had great service from my 1050 however it has gone out of alignment and I can seem to get it right. If anyone lives in the Long Island NY area HELP ME PLEASE. I have been unable to load anything for months.
Quote from Reloader on October 1, 2010, 5:30 pmHey Len, Bill here. I know it's been a little over a month since your question but if you still need help, I've run my 2 Dillon 1050's since 1995. I live in Jersey about 15 minutes thru the tunnel. My number is below if you want to call. It's a lot easier then this typing crap. I also have plenty of spare parts for the 1050 in interrested. Mostly tool heads and powder measures. Thanx. Bill
973-879-9567 all day until about 12 midnight
Hey Len, Bill here. I know it's been a little over a month since your question but if you still need help, I've run my 2 Dillon 1050's since 1995. I live in Jersey about 15 minutes thru the tunnel. My number is below if you want to call. It's a lot easier then this typing crap. I also have plenty of spare parts for the 1050 in interrested. Mostly tool heads and powder measures. Thanx. Bill
973-879-9567 all day until about 12 midnight
Quote from Reloader on May 12, 2011, 3:38 amOne question would be "what is out of alignment?"
Is the indexing "ball bearing" up and locking the shell plate?
Is the shell plate moving too far or not enough?
One question would be "what is out of alignment?"
Is the indexing "ball bearing" up and locking the shell plate?
Is the shell plate moving too far or not enough?