Not Exactly Dillon Equipment, But Dillon Specific
that would certainly work
I went a different route and got a quick disconnect for the powder measure. Here is one example https://entirelycrimson.com/collections/dillon-xl-750/products/dillon-powder-measure-quick-disconnect
the SDB uses a different disconnect and they make one for it also
steps are simple
remove the failsafe pin
pull handle down just a bit
pull the disconnect out enough to clear the powder die (the funnel sits inside of this)
raise the powder measure off the machine
rotate slightly to remove the failsafe rod
now ready to dump the powder back into its container
Takes less time to do it than to read the directions
just another way to skin a cat
Quote from walterlaich on July 3, 2023, 9:11 pmthat would certainly work
I went a different route and got a quick disconnect for the powder measure. Here is one example https://entirelycrimson.com/collections/dillon-xl-750/products/dillon-powder-measure-quick-disconnect
the SDB uses a different disconnect and they make one for it also
steps are simple
remove the failsafe pin
pull handle down just a bit
pull the disconnect out enough to clear the powder die (the funnel sits inside of this)
raise the powder measure off the machine
rotate slightly to remove the failsafe rod
now ready to dump the powder back into its container
Takes less time to do it than to read the directions
just another way to skin a cat
BETTER THAN HOT WATER!!!
Just received a pair of them.....one for pistol and one for rifle powder measures.
Went on easily and will allow powder measure to be taken off and reinstalled in seconds.
Thanks for the link!