overall length issues
Quote from Reloader on July 16, 2016, 7:43 pmI am new to the dillion 650 and have been loading on a single stage press for the last couple years. I have started loading 9mm on my dillion 650 and i am having overall length variances of .010 and was wondering if that was to be expected or if i should be expecting tighter tolerances. im used to my single stage giving me +/- .002 so do i just have to high of expectations or am i possible doing something wrong. Thanks for any help you can provide....
I am new to the dillion 650 and have been loading on a single stage press for the last couple years. I have started loading 9mm on my dillion 650 and i am having overall length variances of .010 and was wondering if that was to be expected or if i should be expecting tighter tolerances. im used to my single stage giving me +/- .002 so do i just have to high of expectations or am i possible doing something wrong. Thanks for any help you can provide....
Quote from Reloader on July 19, 2016, 4:16 pm.010" is well within tolerances. However, if you adjust the seat die with a fired case in station 1, then you get the same upward pressure on your toolhead that you will when you actually reload. This will reduce your variation.
.010" is well within tolerances. However, if you adjust the seat die with a fired case in station 1, then you get the same upward pressure on your toolhead that you will when you actually reload. This will reduce your variation.