Part #20341
Quote from Reloader on March 28, 2019, 2:21 amI ordered the screwdriver, 20341 to investigate why my primer punch wasn’t sitting flush, and have found that it doesn’t fit the retainer on my RL 1050. Are the slots cut into the primer punch hold down screw thicker on a super, than on an RL? The screwdriver blade is too thick to fit my RL.
I ordered the screwdriver, 20341 to investigate why my primer punch wasn’t sitting flush, and have found that it doesn’t fit the retainer on my RL 1050. Are the slots cut into the primer punch hold down screw thicker on a super, than on an RL? The screwdriver blade is too thick to fit my RL.
Quote from Reloader on March 28, 2019, 4:24 pmThere is no dimensional difference in the slot width, other than tolerances. Measure the screwdriver width and the slot width using calipers. It is probably just a few thousanths.
There is no dimensional difference in the slot width, other than tolerances. Measure the screwdriver width and the slot width using calipers. It is probably just a few thousanths.
Quote from Reloader on June 24, 2019, 7:38 pmMine didn't fit the Super 1050 for that matter - apparently just a tolerance/QC at whoever is making these for Dillon. Had to knock a bit off to allow it to fit.
Mine didn't fit the Super 1050 for that matter - apparently just a tolerance/QC at whoever is making these for Dillon. Had to knock a bit off to allow it to fit.