Quote from Reloader on September 1, 2019, 7:11 pm

Hi everybody,
I recently acquired a used square deal B, after many recommendations from friends and reading review after review of happy people I decided I couldn't go wrong and instead of waiting to have the funds to purchase a new one I happened to run across a fair priced used one and bought it. I have had problem after problem but got most all of them taken care of except one. I tighten my powder die down just enough to get enough flare to seat a bullet, if I go up any further on the die than I am I don't get enough flare and shred my bullets. My issue is that even with no casing in station 2 when I pull the handle and the shell plate goes up it still pushed on the powder funnel enough to cause the bar to move about a quarter inch. If I dont throw the charge back in the hopper after this it causes me an over charge by as much as 2 full grains sometimes, if I'm running em through keeping the shell plate full and charging a case every handle pull the charges are perfect and stay the consistency promised. I have tried everything I can think of and have run out of ideas. If anyone has had this problem or knows what to do please let me know. Thanks alot guys