Powder die/measure setup issue
Quote from Reloader on May 26, 2019, 9:40 pmSetting up my new 550C for 9mm. Followed instructions on setting up the powder die/funnel/measure.
It seems I cannot adjust for enough case mouth flare. When it's setup to where the charge bar has full travel, but i get little to no case mouth flare.
When i just for enough case mouth flare, the linkage travels too far and the square bushing pops out.
What am I missing, or doing wrong?
Setting up my new 550C for 9mm. Followed instructions on setting up the powder die/funnel/measure.
It seems I cannot adjust for enough case mouth flare. When it's setup to where the charge bar has full travel, but i get little to no case mouth flare.
When i just for enough case mouth flare, the linkage travels too far and the square bushing pops out.
What am I missing, or doing wrong?
Quote from Reloader on May 28, 2019, 9:27 pmYou probably need to snug the nylock nut on the bellcrank bolt another 1/2 turn or so. This will prevent the bellcrank cube from popping out of the notch.
You probably need to snug the nylock nut on the bellcrank bolt another 1/2 turn or so. This will prevent the bellcrank cube from popping out of the notch.
Quote from Reloader on May 30, 2019, 9:23 pmCheck the powder funnel and compare it to the manual, to ensure the correct powder funnel is being used. Beyond that, please email us some photos to sales@dillonprecision.com , send as a jpeg or pdf attachment.
Check the powder funnel and compare it to the manual, to ensure the correct powder funnel is being used. Beyond that, please email us some photos to sales@dillonprecision.com , send as a jpeg or pdf attachment.