powder measure
Quote from Reloader on May 25, 2008, 1:37 pmI am having a problem with powder falling out of the measure after the case has dropped out of the die. I have the slide going to full stroke. the case is dropped after dropping powder then a little more will hang up and drop all over the press.
Any advise I have tried everything.
Ray
I am having a problem with powder falling out of the measure after the case has dropped out of the die. I have the slide going to full stroke. the case is dropped after dropping powder then a little more will hang up and drop all over the press.
Any advise I have tried everything.
Ray
Quote from Reloader on July 9, 2008, 7:55 pmI had a similar experience but only with very fine powder such as H110/W296. What I did was dissassemble the powder measure/bar and clean the bottom of it well, then reassembled. I surmized that some granuals of powder had slipped between the measure body and the adjustment bar and that created enough space for the problem to get worse and continue.
I had a similar experience but only with very fine powder such as H110/W296. What I did was dissassemble the powder measure/bar and clean the bottom of it well, then reassembled. I surmized that some granuals of powder had slipped between the measure body and the adjustment bar and that created enough space for the problem to get worse and continue.