powder measure tube removal
Quote from Reloader on November 22, 2017, 9:18 pmI have both 550B and SDB machines (2009/2010 vintage). Powder measure has 2 phillips screws that I believe hold the plastic tube in place. In an attempt to remove the tube after removing the screws of course, it doesn't want to budge at all from the housing at the bottom. I'm not beating heck out of it as I don't want to crack/break it. Just want to remove it to clean.
i know in previous versions that the tube was glued in with Black max or the like.
Is there a trick to removing it after taking out the 2 screws or am I being too gentle?
Thanks, Bob
I have both 550B and SDB machines (2009/2010 vintage). Powder measure has 2 phillips screws that I believe hold the plastic tube in place. In an attempt to remove the tube after removing the screws of course, it doesn't want to budge at all from the housing at the bottom. I'm not beating heck out of it as I don't want to crack/break it. Just want to remove it to clean.
i know in previous versions that the tube was glued in with Black max or the like.
Is there a trick to removing it after taking out the 2 screws or am I being too gentle?
Thanks, Bob
Quote from Reloader on November 24, 2017, 4:00 pmIt's possible you are being too gentle. You can throw it into your freezer for a few hours to shrink it as well.
It's possible you are being too gentle. You can throw it into your freezer for a few hours to shrink it as well.
Quote from Reloader on November 24, 2017, 5:30 pmThanks Dillon, as usual, you were right.....I was being too gentle. All set now. thnaks
Thanks Dillon, as usual, you were right.....I was being too gentle. All set now. thnaks