Quote from
Reloader on September 15, 2014, 6:08 pm
I have a new powder hopper for my SD powder thrower. The old one was glued in which is out and the thrower cleaned up. Can you tell us what diameter hole do you drill and how far down from the top edge when updating to a new style reservoir that is held in with two screws. Or shall I give it a thin film of clear epoxy? Thanks.
I have a new powder hopper for my SD powder thrower. The old one was glued in which is out and the thrower cleaned up. Can you tell us what diameter hole do you drill and how far down from the top edge when updating to a new style reservoir that is held in with two screws. Or shall I give it a thin film of clear epoxy? Thanks.
