Primer Problems
Quote from Reloader on December 24, 2019, 9:50 amHey team. Just purchased a 1050. It initially had a 38super set up on it and replaced it with a 9mm kit. Anyways having a terrible time with primer problems. Just wont feed through primer storage tube and then a couple back up for some reason and jam the system up. Stripped and cleaned it three times now with same problems. Looking for ideas/suggestions. Thanks in advance
Hey team. Just purchased a 1050. It initially had a 38super set up on it and replaced it with a 9mm kit. Anyways having a terrible time with primer problems. Just wont feed through primer storage tube and then a couple back up for some reason and jam the system up. Stripped and cleaned it three times now with same problems. Looking for ideas/suggestions. Thanks in advance
Quote from Reloader on December 24, 2019, 2:06 pmMost likely, the primer magazine tip is damaged. To verify, remove the primer magazine tube ( after it is emptied), hold it upright on your bench, so the plastic tip is contacting the top of your bench. Drop one primer, shiny side down, into the top of the tube. Listen for it to slide all the way down. Gently pick up the tube. The primer should be resting on the benchtop. If it is caught in the tip, replace the plastic tip. The pull off and press on.
Most likely, the primer magazine tip is damaged. To verify, remove the primer magazine tube ( after it is emptied), hold it upright on your bench, so the plastic tip is contacting the top of your bench. Drop one primer, shiny side down, into the top of the tube. Listen for it to slide all the way down. Gently pick up the tube. The primer should be resting on the benchtop. If it is caught in the tip, replace the plastic tip. The pull off and press on.