Primer Seating
Quote from Reloader on October 13, 2013, 4:20 pmMy reloader is not seating the primer evenly. The primer is at an angle in the primer pocket. Any ideas on how to address this issue?
Thank you-
My reloader is not seating the primer evenly. The primer is at an angle in the primer pocket. Any ideas on how to address this issue?
Thank you-
Quote from Reloader on October 14, 2013, 10:38 amFirst thing I would check is the primer seating cup. See if you primers are sitting square in it. Second check the installed height of the punch/cup/spring assy. the height from the top of the cup to the bottom of the primer bar should be between 1.215 to 1.220 See page 5 of the manual.
HTH
Jim
First thing I would check is the primer seating cup. See if you primers are sitting square in it. Second check the installed height of the punch/cup/spring assy. the height from the top of the cup to the bottom of the primer bar should be between 1.215 to 1.220 See page 5 of the manual.
HTH
Jim
Quote from Reloader on October 14, 2013, 4:16 pmMost likely cause is the shellplate bolt is not tight enough. Push down on the edge of the shellplate between stations 2 and 3. If it feels springy, then the shellplate bolt is too loose.
Most likely cause is the shellplate bolt is not tight enough. Push down on the edge of the shellplate between stations 2 and 3. If it feels springy, then the shellplate bolt is too loose.