primer tube
Quote from Reloader on May 16, 2017, 12:46 amI have always wondered why the blue deal on the bottom of the small primer tube gets bent, it's a pain to replaced it
I have always wondered why the blue deal on the bottom of the small primer tube gets bent, it's a pain to replaced it
Quote from Reloader on May 16, 2017, 6:02 pmIf the blue magazine orifice is getting bent, the most likely cause is that the primer cup and punch on the end of the primer slide are taller than the factory setting. The manual shows where to measure, and the recommended dimension. In brief, the distance from the underside of the primer slide bar to the top of the primer cup should be 1.410", +/- .003" .
If too tall, use a vise or clamp to reseat the punch and hold it down while you retighten the set screw.
If the blue magazine orifice is getting bent, the most likely cause is that the primer cup and punch on the end of the primer slide are taller than the factory setting. The manual shows where to measure, and the recommended dimension. In brief, the distance from the underside of the primer slide bar to the top of the primer cup should be 1.410", +/- .003" .
If too tall, use a vise or clamp to reseat the punch and hold it down while you retighten the set screw.