Primers not falling
Quote from Reloader on August 7, 2013, 7:39 pmIt just started yesterday, everytime I pull the handle, the primer tray doesn't go far enough back to get the little rod that's holding the primers up to let a primer fall, hope that made sense. If I take it off and push it back by hand it works, just not when it's attached. Any ideas?
It just started yesterday, everytime I pull the handle, the primer tray doesn't go far enough back to get the little rod that's holding the primers up to let a primer fall, hope that made sense. If I take it off and push it back by hand it works, just not when it's attached. Any ideas?
Quote from Reloader on August 8, 2013, 5:17 pmIndeed. There is a burr extending from the bottom of the incline inside the main ram that the primer slide roller rides on. THis burr goes down over the top of the white plastic overtravel block, #13597. To clean this up, use a sharp pointy knife to scrape this burr away. Once gone, the overtravel block will spring out towards you a bit more.
Indeed. There is a burr extending from the bottom of the incline inside the main ram that the primer slide roller rides on. THis burr goes down over the top of the white plastic overtravel block, #13597. To clean this up, use a sharp pointy knife to scrape this burr away. Once gone, the overtravel block will spring out towards you a bit more.