problems
Quote from Reloader on December 1, 2010, 10:58 amone of the pins that holds the tool head in place has broken off. the pin part is still down in the press. i tried to get it out with no luck. i tried to use a magnet, drilled and taped the pin would not pull out. ended up breaking the tap off in it. tried to use a easy out with no luck. what do you suggest i do? i don't know if i can just drill the whole thing out since the tap is broke off in it. need help
one of the pins that holds the tool head in place has broken off. the pin part is still down in the press. i tried to get it out with no luck. i tried to use a magnet, drilled and taped the pin would not pull out. ended up breaking the tap off in it. tried to use a easy out with no luck. what do you suggest i do? i don't know if i can just drill the whole thing out since the tap is broke off in it. need help
Quote from Reloader on December 1, 2010, 4:43 pmThe easiest way to remove it is to use a small punch and a hammer to drive the pin out through the bottom of the frame. It won't damage the frame, and is much easier to do than drilling and easy-out.
The easiest way to remove it is to use a small punch and a hammer to drive the pin out through the bottom of the frame. It won't damage the frame, and is much easier to do than drilling and easy-out.
Quote from Reloader on December 2, 2010, 11:07 amit worked out great thanks for the help i guess i should of asked for your advice sooner.
it worked out great thanks for the help i guess i should of asked for your advice sooner.