Question for Dillon
Quote from Reloader on April 27, 2013, 2:32 amI installed all the correct parts on the case feed , but my 3006 cases won't drop all the way down . What could be the problem ?
I installed all the correct parts on the case feed , but my 3006 cases won't drop all the way down . What could be the problem ?
Quote from Reloader on April 27, 2013, 1:15 pmYou did not state how much of the case hangs and where;
The two common problems I see are:
1) The case insert slide was not switched from pistol to rifle. See page 37 of the manual, picture 182. The slide also has some adjustment see figure 187.
2) If not that then check the camming pin , Fig 188.Remember on long rifle cases like 30-06, you may need to pause on the bottom of the down stroke to allow the case to fall and raise handle up slower than on pistol. Raising slowly will also allow you to see what/where the case is hanging up.
You did not state how much of the case hangs and where;
The two common problems I see are:
1) The case insert slide was not switched from pistol to rifle. See page 37 of the manual, picture 182. The slide also has some adjustment see figure 187.
2) If not that then check the camming pin , Fig 188.
Remember on long rifle cases like 30-06, you may need to pause on the bottom of the down stroke to allow the case to fall and raise handle up slower than on pistol. Raising slowly will also allow you to see what/where the case is hanging up.
Quote from Reloader on April 27, 2013, 1:33 pmIt was number 1 . I found the problem this morning , after a good nights sleep . I think I was too tired to notice what was wrong last night .
Thank you very much for your help , and quick reply .
It was number 1 . I found the problem this morning , after a good nights sleep . I think I was too tired to notice what was wrong last night .
Thank you very much for your help , and quick reply .