Resizing Die
Quote from Reloader on May 31, 2017, 8:28 amHello, I was processing military brass and I bent the depriming rod on the .223 carbide resizing/decapping die. What is the part number I need to order to replace it? The pictures on the webpage and what I have seem different. I'm running the Super 1050. Thank you.
Charles
Hello, I was processing military brass and I bent the depriming rod on the .223 carbide resizing/decapping die. What is the part number I need to order to replace it? The pictures on the webpage and what I have seem different. I'm running the Super 1050. Thank you.
Charles
Quote from Reloader on May 31, 2017, 12:48 pmWhere is it bent? If its on the lower part only, you just need the pin #13278. if it was further up, the bolt section is #13182. FYI, the expander ball is #13269. Purchase a few extras if you're loading a lot, especially mixed brass. There have been times that I have bent either or both. It's a fast replace if you have the whole assembly together.
Where is it bent? If its on the lower part only, you just need the pin #13278. if it was further up, the bolt section is #13182. FYI, the expander ball is #13269. Purchase a few extras if you're loading a lot, especially mixed brass. There have been times that I have bent either or both. It's a fast replace if you have the whole assembly together.
Quote from Reloader on May 31, 2017, 3:34 pmIt was the lower part. Thank you very much. I'll get some spares so I'm not knocked out of service too long.
It was the lower part. Thank you very much. I'll get some spares so I'm not knocked out of service too long.