RL 1050 case feeder tube
Quote from Reloader on January 6, 2014, 1:08 amJust got my RL1050 back from a factory overhaul. Loaded a few thousand 223s and now I have switched to my 9mm tool head. Got everything back together but now my case feed tube is an inch and a half too short from fitting into the case feeder mechanism. I'm scratching my head trying to figure out how it worked with the 223. My old case feeder tube was a nice tight fit from the case sorter to the case feeder. Is there a length difference between the RL1050 case feeder tubes and the Super 1050 case feeder tubes?
Just got my RL1050 back from a factory overhaul. Loaded a few thousand 223s and now I have switched to my 9mm tool head. Got everything back together but now my case feed tube is an inch and a half too short from fitting into the case feeder mechanism. I'm scratching my head trying to figure out how it worked with the 223. My old case feeder tube was a nice tight fit from the case sorter to the case feeder. Is there a length difference between the RL1050 case feeder tubes and the Super 1050 case feeder tubes?
Quote from Reloader on January 6, 2014, 4:50 pmIt sounds like the plastic case feed bowl is not bottomed out onto the post. Be sure no flashing is interfering with the bowl seating properly.
It sounds like the plastic case feed bowl is not bottomed out onto the post. Be sure no flashing is interfering with the bowl seating properly.