SDB dis-assembly
Quote from Reloader on June 13, 2013, 2:14 amI have searched to no avail. I want to be able to see video/photos of how to dis assemble, clean, lube and re-assemble my SDB.
Also bought the maintenance kit, but no cleaning fluid or suggestion... I have the lube.
any help would be appreciated.
thanks
I have searched to no avail. I want to be able to see video/photos of how to dis assemble, clean, lube and re-assemble my SDB.
Also bought the maintenance kit, but no cleaning fluid or suggestion... I have the lube.
any help would be appreciated.
thanks
Quote from Reloader on June 14, 2013, 3:03 amHi
I had to read your post twice because it was the one I submitted.
I finally gave up and went at it myself. Used alcohol to clean and the maintenance kit grease.
I thought about doing photos but was anxious to see if I could put it back and have it work as well as it did. Before.
It took the luring steps from the Enos forum plus a highlighter and the schematic from the first page,of the,users manual . I suggest keeping parts,as close,to,the way you took them off and take photos is you go. Keep items that are on the right side of the press on the right side etc.
I went slowly and carefully... You will probably have,to remove the linkage for the powder measure. Good,idea to measure the length of the thread that protrudes thru the bracket on the bottom and duplicate the same length when you re-assemble.Hope,this helps... When I got it,done and tried some test ammo to make sure,that powder, case length was correct and it slid,thru my case gauage I felt like like a genius.
If,you,hav a specific question I would be glad,to try and help.
Hi
I had to read your post twice because it was the one I submitted.
I finally gave up and went at it myself. Used alcohol to clean and the maintenance kit grease.
I thought about doing photos but was anxious to see if I could put it back and have it work as well as it did. Before.
It took the luring steps from the Enos forum plus a highlighter and the schematic from the first page,of the,users manual . I suggest keeping parts,as close,to,the way you took them off and take photos is you go. Keep items that are on the right side of the press on the right side etc.
I went slowly and carefully... You will probably have,to remove the linkage for the powder measure. Good,idea to measure the length of the thread that protrudes thru the bracket on the bottom and duplicate the same length when you re-assemble.
Hope,this helps... When I got it,done and tried some test ammo to make sure,that powder, case length was correct and it slid,thru my case gauage I felt like like a genius.
If,you,hav a specific question I would be glad,to try and help.