Size/trim toolhead
Quote from Reloader on February 11, 2018, 1:30 amBeing that the size/trim die and machine don’t fit on the toolhead with the powder measure and other dies I have set up a toolhead just for this purpose. Do you think this will cause some sort of balance issue with the dies only pushing on 3 of the 5 stations? That’s part of the reason I did this as well, it seemed like the FL size station was getting a lot of pressure.
Also, I live in AZ, can I just bring my press in for clean/lube/repair? I started having trouble with the primer feed.
Being that the size/trim die and machine don’t fit on the toolhead with the powder measure and other dies I have set up a toolhead just for this purpose. Do you think this will cause some sort of balance issue with the dies only pushing on 3 of the 5 stations? That’s part of the reason I did this as well, it seemed like the FL size station was getting a lot of pressure.
Also, I live in AZ, can I just bring my press in for clean/lube/repair? I started having trouble with the primer feed.
Quote from Reloader on February 11, 2018, 4:31 amthe trim die should be on a separate toolhead, usually at station 4 on the 650, run the cases through the trim die, then switch to the regular toolhead and run them through.
There's a response from Dillon to that same question that I'd posed a couple of years ago that recommends that procedure.
the trim die should be on a separate toolhead, usually at station 4 on the 650, run the cases through the trim die, then switch to the regular toolhead and run them through.
There's a response from Dillon to that same question that I'd posed a couple of years ago that recommends that procedure.
Quote from Reloader on February 13, 2018, 10:24 pmjoe answered your question quite well. You are welcome to drop a machine off at our retail store for work. Just be aware it will be close to a couple of weeks before it will be ready for pickup. We will phone or email you when your machine is ready.
joe answered your question quite well. You are welcome to drop a machine off at our retail store for work. Just be aware it will be close to a couple of weeks before it will be ready for pickup. We will phone or email you when your machine is ready.