Sizing & Depriming Die

#1 · November 7, 2012, 8:28 am

Hi,

I'm about to buy a conversion kit from 9mm to 38SuperComp.

May I know if the sizing die will size the case further down to the bottom or it will still have the bluged near the base?

If not, will the EGW undersizing die OR the LEE undersizing die fit the thread of the SDB? As I had notice the thread fo the sizing die is smaller on the SDB and is not seems universal. Please advise.

#2 · November 7, 2012, 3:48 pm

If your chamber properly supports the case, you shouldn't have any bulging issues. The SDB uses propietary dies, will not accept any other brands of dies.