Small Magazine tip
Quote from Reloader on February 24, 2009, 12:34 amI have an older SDB. I keep having problems with the small (blue) magazine tip tearing/ distorting after about 300 rounds. It happens with CCI 500s and WSPs. I have tried different tightnesses of the knurled keeper nut, but keep having the same issue.
Any thoughts?
I have an older SDB. I keep having problems with the small (blue) magazine tip tearing/ distorting after about 300 rounds. It happens with CCI 500s and WSPs. I have tried different tightnesses of the knurled keeper nut, but keep having the same issue.
Any thoughts?
Quote from Reloader on February 24, 2009, 4:43 pmIt sounds like the primer cup and punch may not be fully seated in the primer slide. Using calipers, measure from the underside of the primer slide to the top of the cup. This should measure 1.410", +/- .003". If too tall, use a clamp or vise to reseat, then retighten the set screw.
It sounds like the primer cup and punch may not be fully seated in the primer slide. Using calipers, measure from the underside of the primer slide to the top of the cup. This should measure 1.410", +/- .003". If too tall, use a clamp or vise to reseat, then retighten the set screw.
Quote from Reloader on February 28, 2009, 10:40 pmDillon was right, I was having the same problem with the large magazine. after adjustment everything was ok. thanks
Dillon was right, I was having the same problem with the large magazine. after adjustment everything was ok. thanks
Quote from Reloader on June 4, 2010, 6:31 pmDillon,
I've having similar problems tearing up red tips...
Measuring 1.390" from top of primer cup to bottom of slide...Pls advise...
Dillon,
I've having similar problems tearing up red tips...
Measuring 1.390" from top of primer cup to bottom of slide...
Pls advise...