small primer
Quote from Reloader on November 25, 2014, 11:57 pmReloading 9 mm small primer not seating all the way in
pushing the handle all the way back.???
Reloading 9 mm small primer not seating all the way in
pushing the handle all the way back.???
Quote from Reloader on November 26, 2014, 12:30 amTry the following:
1. Make sure shell plate is all the way down. Tighten
with the supplied Allen wrench to the point where you are
unable to turn the sprocket by hand. Now, back off the bolt
slightly, allowing you to push the sprocket easily with your
thumb (page 7 of owners manual).2. check out page 5 of the owners manual. There is a picture on bottom left that shows the primer slide and primer punch set screw with other parts and how they should be set up. Check setting and make sure 13996 Primer Punch Set Screw is tight.
3. Make sure you are pressing handle all the way to the back of the press to set primer into case.
The owners manual is available online under bar at top of webpage (Manuals).
Try the following:
1. Make sure shell plate is all the way down. Tighten
with the supplied Allen wrench to the point where you are
unable to turn the sprocket by hand. Now, back off the bolt
slightly, allowing you to push the sprocket easily with your
thumb (page 7 of owners manual).
2. check out page 5 of the owners manual. There is a picture on bottom left that shows the primer slide and primer punch set screw with other parts and how they should be set up. Check setting and make sure 13996 Primer Punch Set Screw is tight.
3. Make sure you are pressing handle all the way to the back of the press to set primer into case.
The owners manual is available online under bar at top of webpage (Manuals).