Station 4 - Seating Die

#1 · March 8, 2020, 1:42 am

New XL750. Setting up for 9mm. Using Campro semi wad cutter bullets. I have run out of adjustment. Is there a thinner Die Lock Ring? Or have I screwed up?

Bob

#2 · March 8, 2020, 3:28 pm

You should be able to put a lock ring on the under side of the toolhead. If the brand of die you are using requires it. Kind of an uncommon occurrence.

#3 · March 13, 2020, 4:53 pm

remove the die lock ring, and adjust the die. As long as at least one full thread is visible above the toolhead, the lock ring will lock it in place. Just Pull the clip from the top of the die, add the lock ring.