strong mount
Quote from Reloader on October 18, 2016, 1:00 pmwas thinking about mounting a strong mount to about two or three sheets of maple plywood, then mounting that to the top of a roll around craftsman toolbox. would this work?
was thinking about mounting a strong mount to about two or three sheets of maple plywood, then mounting that to the top of a roll around craftsman toolbox. would this work?
Quote from Reloader on October 18, 2016, 4:07 pmPlywood might flex enough to prevent consistent primer seating. Use one inch thick particle board, and maybe add a maple plywood like a top cover.
Plywood might flex enough to prevent consistent primer seating. Use one inch thick particle board, and maybe add a maple plywood like a top cover.
Quote from Reloader on October 18, 2016, 5:45 pmthe particle board that i am thinking of will flex way to much, as for the thickness i am thinking at least 3/4''
the particle board that i am thinking of will flex way to much, as for the thickness i am thinking at least 3/4''
Quote from Reloader on October 18, 2016, 7:27 pmSo you're thinking of 2 to 3 layers of 3/4" plywood that is then bolted down to the roll away? That should work. I'd add some stiffeners on the underside of the roll away top as well.
Kevin
So you're thinking of 2 to 3 layers of 3/4" plywood that is then bolted down to the roll away? That should work. I'd add some stiffeners on the underside of the roll away top as well.
Kevin