Super Swagger
Quote from Reloader on December 17, 2010, 2:03 pmI am having some trouble with the super swagger. When the brass is layed down and in position to be swagged, the rod that slides into the case sits a little to low in the carrier and the swagging button hots the brass out side of the primer pocket.
Is there a way to adjust the height of the area that the brass sits on prior to swagging?
Thanks
Jerry
I am having some trouble with the super swagger. When the brass is layed down and in position to be swagged, the rod that slides into the case sits a little to low in the carrier and the swagging button hots the brass out side of the primer pocket.
Is there a way to adjust the height of the area that the brass sits on prior to swagging?
Thanks
Jerry
Quote from Reloader on December 17, 2010, 3:49 pmThere is a spring-loaded flat block in the bottom of the frame. It's height is locked in place by a set screw in the side of the frame. Loosen this set screw to allow it to spring up, set a case on the backup rod, align it with the swage rod and pull the handle down. Align the case with the swage rod by hand. Then snug the set screw on the side to secure the spring-loaded block in place.
There is a spring-loaded flat block in the bottom of the frame. It's height is locked in place by a set screw in the side of the frame. Loosen this set screw to allow it to spring up, set a case on the backup rod, align it with the swage rod and pull the handle down. Align the case with the swage rod by hand. Then snug the set screw on the side to secure the spring-loaded block in place.