Toolhead and Shellplate are not in line ?
Quote from Reloader on April 29, 2017, 8:58 pmHello
First day with my first Dillon and there is one thing to be corrected.
Die of Toolhead and Shellplateposition are not in line. During upstroke the case gets into the die, because of the disalignement the case pushes the shellplate a bit. During downstroke the case gets out of the die and the shellplate turns back the little movement.
How can the alignement be adjusted?
THX
Hello
First day with my first Dillon and there is one thing to be corrected.
Die of Toolhead and Shellplateposition are not in line. During upstroke the case gets into the die, because of the disalignement the case pushes the shellplate a bit. During downstroke the case gets out of the die and the shellplate turns back the little movement.
How can the alignement be adjusted?
THX
Quote from Reloader on April 30, 2017, 3:58 pmHi
Sorry cannot check it now, ring indexer broke....
but the brass was always perfect set at the 5 positions.
I think the platform is not in line.
Hi
Sorry cannot check it now, ring indexer broke....
but the brass was always perfect set at the 5 positions.
I think the platform is not in line.
Quote from Reloader on May 2, 2017, 11:02 pmThe platform alignment tool is used to ensure the shellplate guides the cases up into the dies. Please email us requesting an alignment tool, and we will be happy to mail one to you. Please include your mailing address with your email.
The platform alignment tool is used to ensure the shellplate guides the cases up into the dies. Please email us requesting an alignment tool, and we will be happy to mail one to you. Please include your mailing address with your email.
Quote from Reloader on May 4, 2017, 6:12 pmThx a lot, sent a request yesterday.
Would it be possible for you to check, if the tool is sent to me?
Thanks!
Thx a lot, sent a request yesterday.
Would it be possible for you to check, if the tool is sent to me?
Thanks!
Quote from Reloader on May 10, 2017, 11:54 amTool came in yesterday.
Tool proves that the platform is not in line!
Changes on the screws of the platform to align the tool correctly the case feed system (see my other post) has a collision.
The alignment of the case feed system is wrong, but it is fixed mounted to the body of the press.
The Case slide has a collision with the bottom case tube on the left side (bigger finger).What should I do?
Tool came in yesterday.
Tool proves that the platform is not in line!
Changes on the screws of the platform to align the tool correctly the case feed system (see my other post) has a collision.
The alignment of the case feed system is wrong, but it is fixed mounted to the body of the press.
The Case slide has a collision with the bottom case tube on the left side (bigger finger).
What should I do?