Trimming Step
Quote from Reloader on November 9, 2010, 5:10 amAnyone at the "Blue Press" monitoring these posts? It's been three days...
I trim brass with the 1200 (it's great) and its sized at the same time.....
Can I get away with setting stage one up to run the ball through the neck or do I need to go through the whole process of lubing cases and running them through the press again??
Anyone.... What works??!!
Anyone at the "Blue Press" monitoring these posts? It's been three days...
I trim brass with the 1200 (it's great) and its sized at the same time.....
Can I get away with setting stage one up to run the ball through the neck or do I need to go through the whole process of lubing cases and running them through the press again??
Anyone.... What works??!!
Quote from Reloader on November 9, 2010, 2:33 pmIf you are using a flat-based bullet, then I do recommend pushing the expander ball through the case mouth before loading. With boat-tailed bullets it is not required, but I do it for match ammo.
If you are using a flat-based bullet, then I do recommend pushing the expander ball through the case mouth before loading. With boat-tailed bullets it is not required, but I do it for match ammo.